XENOPIXEL Lightsaber Configuration Manual

XenoPixel settings can be changed by rewriting the SD card.

To change settings, you need to read the SD card installed on the board with a PC.

*Important* Save a backup of your SD data before changing settings.

After accessing the SD, open the set folder and click config.

To change ON/OFF by motion, set the following status to 1 or 0.

After rewriting and saving, please reinstall the SD into the lightsaber and check the operation.

■Stub twist ON/OFF

StabPwrOn...Stub ON is enabled when set to 1, disabled when set to 0.

StabPwrOff... Stub OFF is enabled when set to 1, disabled when set to 0.

■Motion twist ON/OFF

TwistPwrOn... When set to 1, twist ON is enabled, and when set to 0, it is disabled.

TwistPwrOff... Twist OFF is enabled when set to 1, disabled when set to 0.

■Motion swing ON

SwingPwrOn... Swing ON is enabled when set to 1, disabled when set to 0.

This content is a manual for firmware version DD06 (January 2022 version). Operations may differ slightly depending on the version. Please note.