How to assemble the saver stand

This page will show you how to assemble the new 89Sabers Lightsaber Stand. The simple parts make for a smooth assembly.

1. Check the accessories

Open the package and check that the following parts are included:

• Front plate x 1
• Side plates x 2
  
• 6 x screws
• Fixing wrench x 1

2. Assembly Instructions

① Insert the included screws into the base plate.
In this case, the base plate (the long, horizontal part) has two sides: one with a recess to fit the screw head, and one flat side.

Insert the screw from the recessed side of the screw head.
* If installed backwards, the screw heads will not fit into the plate, causing it to wobble or become unstable.

② After inserting the screw, tighten it firmly with the included L-shaped wrench.
Secure the front and both side supports and you're done.

3. Precautions

• The support pole is made of acrylic, so please handle it carefully as it may break if you apply too much force.
• The base plate may have a protective film attached. Please remove it if necessary.
• For double savers and stands with special shapes, the assembly method may differ.
• Design and specifications are subject to change.