XENO3 Reset Procedure

Introduction

This page provides instructions on how to reset your XENO3-equipped custom lightsaber to its factory settings. If you have customized the colors or effects and wish to revert to the initial settings, please follow the steps below.

ATTENTION

XENOPIXEL XENO3 Settings Change Manual

Instructions

Step 1: Download and extract the initial settings file from the URL below.

Of these, fonts 1-33 are standard manufacturer fonts, and those fonts do not have a fontconfig file (initial settings file), so only 34-46 are applicable.

■ Google Drive

https://drive.google.com/file/d/1WAEgBM7a9p-lfw_l2mKYHIQ26tbPY_Sj/view?usp=drive_link

Initial file download image

Step 2: Put the saber hilt into one of the following states:

  • Sleep mode
  • Kill switch OFF
  • Battery removed

Then, remove the SD card from the hilt.

Step 3: Open the SD card on your computer and overwrite it with the file you downloaded and extracted in Step 1.

If files with the same name exist, select "Replace files".

Overwrite confirmation image

Step 4: Reinsert the SD card into the saber hilt and check if it functions correctly.

Other Notes

The contents of the initial settings file may vary depending on the saber model and purchase date.

Last updated: July 8, 2026

Version used: Ver1.4